The installation of hot-press plate cushion needs correct guidance, otherwise, improper installation will cause serious consequences.
When installing the cushion pad of the hot press, the cushion pad must be installed in the center of the heat conducting plate of the hot press and the stainless steel formwork in the order from top to bottom. The cushion must be laid flat. First, not fixed, to avoid the introduction of debris in the pavement. Then the temperature will be raised to 60 - 80 degrees Celsius, and the pressure will be increased to make the pressure plate into a fine closed state. In the process of fixing, only four angles of fixed length direction are needed, and the best width direction is not fixed. After pressing more than 200 - 300 sheets, the cushion shrinks slightly due to heating. It needs to adjust the tension of cushion from scratch after shutdown. Press more than 200 - 300 sheets and adjust them again. Recently, some cushion pads on the market have positive and negative sides. As far as possible, one side of the copper wire faces the template, which is the heat preservation surface and the heat conduction plate of the press.
What should we pay attention to when installing hot-pressing plate cushion is provided by Kunshan Hongxin Hot-pressing Plate Co., Ltd.